ANYCUBIC WASH & CURE 3 PLUS

Size Upgrade, Capacity Increased

Compared with Anycubic Wash & Cure Plus, the washing volume of the washing basket is increased by about 13.4% to 7.6 liters, and the total volume of the washing bucket is 12 liters, which is suitable for light-curing 3D printers of 10.6 inches and below.

At the same time, the curing size has increased by 42%, up to φ220*260 millimeters, to accommodate larger and more models for single post-processing session.

Overall Curing And Partial Enhanced

The innovative Flexicure gooseneck lights design increases the energy value by 30,000uW/cm²* in the 1~3cm irradiation range, which greatly enhances the curing effect on details such as the top of the model and the figure's skirt.

The Anycubic Wash & Cure 3 Plus features a brand-new arrangement of lamb beads combined with a lens light source. Compared to the previous generation Anycubic Wash & Cure Plus, it offers a 20% improvement in curing uniformity*. This results in a more thorough and comprehensive overall curing of the model, ensuring better quality and consistency.

Dual-Layer Design, IPA Saving

The dual-layer PP material cleaning basket supports washing with platform. It is equipped with two adjustable heights of 150 millimeters and 250 millimeters, allowing printing platforms from 6.6 to 10.6 inches, maximizing alcohol usage efficiency.

A brand-new dual-layer curing platform has been adopted, which increases the number of models cured per cycle and greatly improves the curing efficiency.

Simple Operation, Quiet and Efficient

Cleaning and curing dual modes, easily selected with one click; Enhanced Gooseneck light curing mode can be easily toggled on and off with one click. Cleaning and curing time can be easily adjusted from 1 to 30 minutes at will.

Through a more sealed structural design and software optimization, the noise interference generated during cleaning and curing is reduced[1], creating a quieter and more comfortable working environment.

In The Box