Αρχική/ARDUINO/SHIELDS & MODULES/W5500 Ethernet Network Module Hardware TCP/IP Interface 51/STM32 Program Driver

W5500 Ethernet Network Module Hardware TCP/IP Interface 51/STM32 Program Driver

Κωδικός Κατασκευαστή (MPN): HS1503

ΚΩΔΙΚΟΣ: AA1135

W5500 Ethernet Network Module Hardware TCP/IP Interface 51/STM32 Program Driver Support hardware TCP/IP protocol: TCP, UDP, ICMP, IGMP, IPv4, ARP, IGMP, PPPoE and Ethernet Support 8 independent ports (sockets) Very compact LQFP48 lead-free package Provide sleep mode Provide network wakeup...

€8¹⁷

Χωρίς ΦΠΑ: €6.59

Σε Απόθεμα

+ −

Παράδοση

— ELTA Courier
— ACS Courier
— ΓΕΝΙΚΗ ΤΑΧΥΔΡΟΜΙΚΗ

Τρόποι πληρωμής

Περιγραφή
Χαρακτηριστικά
Skroutz Αξιολογήσεις

W5500 Ethernet Network Module Hardware TCP/IP Interface 51/STM32 Program Driver

Support hardware TCP/IP protocol: TCP, UDP, ICMP, IGMP, IPv4, ARP, IGMP, PPPoE and Ethernet

Support 8 independent ports (sockets)

Very compact LQFP48 lead-free package

Provide sleep mode

Provide network wakeup

Support for high speed SPI bus (SPI mode 0, 3)

Internal 32K byte memory as TX/RX cache

Embedded 10/100Mbps Ethernet physical layer

Support auto-negotiation (10/100-Based full/half duplex)

IP segmentation is not supported

3.3V working voltage, I/O port can withstand 5V voltage

Multiple indicator signal outputs (full duplex / half duplex mode, network connection and network speed)

Pin	Function Description	Pin	Function Description
3.3V	3.3V power input pin	5V	5V power input pin
MISO	SPI master input slave output pin	GND	Power ground pin
MOSI	SPI master output slave input pin	RST	W5500 hardware initialization pin (active low)
SCS	SPI SLAVE select pin (active low)	INT	W5500 interrupt pin (active low)
SCLK	SPI clock pin	NC	Hanging

Note 1: The operating voltage of the W5500 is 3.3V, but the I/O port can withstand 5V.

Note 2: The YIXIN_W5500 module has two power supply modes, namely 3.3V power supply or 5V power supply. When using 5V power supply, the “3.3V” pin will have a 3.3V voltage output.

Προβλήθηκαν Πρόσφατα