Αρχική/ΗΛΕΚΤΡΟΝΙΚΑ/SENSORS/TEMPERATURE / HUMIDITY/Gravity: Non-contact Digital Water / Liquid Level Sensor For Arduino

Gravity: Non-contact Digital Water / Liquid Level Sensor For Arduino

Κωδικός Κατασκευαστή (MPN): SEN0204

ΚΩΔΙΚΟΣ: AA0780

MANUFACTURERDFROBOT MPNSEN0204

€18⁰³

Χωρίς ΦΠΑ: €14.54

Σε Απόθεμα

+ −

Παράδοση

— ELTA Courier
— ACS Courier
— ΓΕΝΙΚΗ ΤΑΧΥΔΡΟΜΙΚΗ

Τρόποι πληρωμής

Περιγραφή
Χαρακτηριστικά
Skroutz Αξιολογήσεις

INTRODUCTION

This is a non-contact water / liquid level sensor for Arduino. It utilizes advanced signal processing technology by using a powerful chip (XKC-Y25-T12V) with high-speed operation capacity to achieve non-contact liquid level detection. No contact with liquid makes the module suitable for hazardous applications such as detecting toxic substances, strong acid, strong alkali and all kinds of liquid in an airtight container under high pressure. There are no special requirements for the liquid or container and this liquid sensor is easy to use and easy to install. You may also check Liquid Sensor Selection Guide to get better familar with our liquid sensor series.

The liquid level sensor is equipped with an interface adapter that makes it compatible with DFRobot "Gravity" interface. Four levels of sensitivity can be configured by pressing the SET button.

Gravity: Non-contact Arduino Water Liquid Level Sensor XKC-Y25-T12V — Diagram for Non-contact Liquid Level Sensor with Arduino

SPECIFICATION

Chip: XKC-Y25-T12V
Interface:Gravity Digital

Προβλήθηκαν Πρόσφατα